1 / 1
QIDI Q1 Pro extended filament waste bucket — zdjęcie 1

QIDI Q1 Pro extended filament waste bucket

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Waste bucket with extended top to prevent the purged filament from missing the bucket.

Ocena
0 / 5
Polubienia
14
Pobrania
75
Wydruki
0
Wyświetlenia
492
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

The original bucket is too small, sometimes the purged filament will not fall into it.

I make the new one with the extended top to prevent this issue.

Due to the heat of the chamber, it is better to print it with ABS or PETG.

 

Print the model upside down, with the top part on the bed with brim for better adhesion.

You need to support the pin of the bucket.

 

The bottom part of the bucket should be bridgeable, just make sure it bridges on the short side.

You could change the bridge infill direction (bridge angle) to achieve that.