Ender 2 Pro Handle with Spool Bracket & Light Bar Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ender 2 Pro Handle with Spool Bracket & Light Bar Holder. Still requires the addition of Creality Ender-3 Pro Filament.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 169
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
Ender 2 Pro Handle with Spool Bracket Pocket & Light Bar Holder
I found the Creality Ender 3 Pro Filament Support Bracket at Microcenter and thought it would make a good addition to my Ender 2 Pro. It cost only $2 dollars, cheaper than filament.
https://www.microcenter.com/product/625620/creality-ender-3-pro-filament-support
Not sure where else to get it for that price.
When if found the “Handle, Creality Ender 2 Pro” by eSeL, I thought it would be a good fit with the "Ender 3 Filament Guide" by Filboyt.
The handle, designed with Tinkercad, adds a recessed pocked to insert the Filament Support Bracket, for both front and back mounting of the bracket. I printed Handle with supports, and it was difficult to remove the pocked support. In the end it came out just as I thought it would. The bracket and Handel are connected using the same screws the original handle used. It could be rotated but I wanted to keep the top of the handle on the print bed to get a more finished textured look.
The Z-Rod Cover is a slight modification of the original “guide_v3”.
The additional of the Left and right Light Bar Holder caps off the design. The tight friction fit seams to be enough to hold the fitting in place.