Spinning Soldering Tip & Heat Set Insert Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
As the name says, its a spinning soldering tip and heat set insert holder.
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 17
- Wydruki
- 1
- Wyświetlenia
- 109
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
I was inspired by a product I saw on amazon, but they didn't sell the holder without the tips and also there was no way to hold heat set inserts with it so I decided to make one myself. Works best when on a desk mat or silicon soldering mat.
It will hold Hakko or other 7mm diameter tips, and I designed it to fit the heat set insert tips sold by Hanglife. The holes for the heat set inserts are designed for a 4mm diameter.
To print this I recommend using my print profile as I have modified some settings to add support under the top piece and extra infill in the shaft that holds the bearing on the bottom piece to prevent breaking while pressing the bearing.
The holder is assembled by pressing a bearing into the bottom of the top piece and then pressing the bearing onto the shaft of the bottom piece. You can either print your own 608 bearing from a number of different models found on here and other websites or you can use a real 608 bearing. If you're going to buy a bearing, make sure its a nice free spinning one that would be good for a fidget spinner, some bearings are full of thick grease that won't work well for this. I used a Bones Redz 608 bearing for mine. While the 3d printed bearing will work, it won't be nearly as satisfying (I tested a couple)