Landscape Nebula pad mount for Lack enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I like balla's guppyscreen (https://github.com/ballaswag/guppyscreen) on my Creality Ender 3 v3 KE, but since I use my…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 221
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I like balla's guppyscreen (https://github.com/ballaswag/guppyscreen) on my Creality Ender 3 v3 KE, but since I use my old Ender 3 IKEA Lack enclosure, there is no room inside to mount the Nebula pad horizontally.
Also, I like to have the display outside so the doors could remain closed when printing ABS or the like.
I searched a bit and than decided to use the brackets from https://www.printables.com/model/561871-hyperpixel-4-lack-enclosure-mount (included, but all credits go to @vinnie_289722 and @EmmaL_101520 ) and my self designed pad holder, inspired by the original holder.
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 V3 SE
No
Supports:
No
0.2mm
Infill:
I used 33% gyroid
Notes:
There is no KE in the Printer Models ;)
Just use M3 heat inserts and short (6-8mm) M3 screws to mount the brackets to the holder. You have to find or make an extension for the 10 pin flat cable from printer to pad. I used https://www.amazon.de/dp/B08QGV9765, but you can build your own extension e.g with DuPont cables, which happen to have 2.54mm pitch like the flat cable. Just be careful to connect all pins 1:1. Or use flat cables and one female and one male 10 pin connector.
How I Designed This
I am no designer, so as always in such cases, I tried my best with OpenSCAD (and the rounded corner module https://danielupshaw.com/openscad-rounded-corners/)
Category: 3D Printer Parts