Overhead pipe clamp storage bracket

I have some long pipe clamps that I wanted to store on the low part of the ceiling in my garage. I designed these brackets. You will need to print them in pairs. I know they will fit on a Bambu 256x256 print bed. Unfortunately this model will not fit on an Ender 3-type 220x220 bed.

Print in pairs. I recommend PETG with four walls and 20-25% of cubic infill. I do not recommend PLA. I think the PLA will weaken and warp over time, particularly with longer pipe clamps. The design is optimized for FDM printing. Print with the big flat side down. No supports are needed. 

When mounting, they need to be mirrored from each other offset from each other by about 27mm so the holes in one bracket align with the saddles in the other bracket. It doesn't have to be exact. I designed these so that the “pipe” end of a clamp slips through the hole on one end and the “clamp” end lifts up and into a little saddle.