Shoelace Anchors
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shoelace Anchors
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 222
- Wydruki
- 5
- Wyświetlenia
- 1196
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Shoe lace anchors for your shoes to convert them to no tie shoes. There is a commercial version that I used in the past, but since have been lost because I tossed the shoes that had them. Since it was such a simple, yet effective design, I decided to create my own. This holds up extremely well, only tested in PLA. 3mf and stl files come with single or pairs, since you need two per shoe. This is slightly larger than the original, roughly 50% to fit my lace anklets. A full set of 4 in these settings take about 29 minutes to print.
Nozzle: 0.4 mm
Layer height: 0.1mm
Vertical Perimeters: 4
Infill: 100%