S10 steering column mount adapter

Like most 2nd gen S10 pickups and blazers, the plastic dash parts have broken into pieces. The recessed mounting holes on the underside of the steering column panel are a common break point. Rather than buy a whole new panel, I made these simple adapter/grommets to hold the washer and screw. This works for sure on the top two, haven't broken the bottom two yet. It may or may not sit totally flush depending on which hole it is. Someone else can remix it to be flush specific to each of the four mounts.

Print Settings

Rafts:

Doesn't Matter

Supports:

**Resolution:**

.2

Infill:

Notes:

Print at 45° angle for the least supports and strongest orientation. Highly recommend using at least 3 walls.

Post-Printing

If your overhang settings aren't dialed in, there may be some imperfection on the inside of the adapter. Threading the washer and screw in cut through it fine however. If the inner diameter were any larger, the adapter would be too thin to support the pressure of the screw mount.

Category: Automotive