MSI GPU Thumbdrive (Dual Extrusion Possible)

We included a few options in files. There are 2 editions Verbatim (GTX11) and Kingston. The kingston version has a deeper hole for the USB stick. While the Verbatim has a less deep hole for very small USB sticks. The kingston stick is around 39mm deep. If unsure of which version to choose I would suggest the Kingston version.

EDIT: Now there is also a 3.0 version. This one has a very large hole, same size as the other Kingston sticks. However the bottom part is loose, this way it is easier to get the supports out which were quite difficult.

I used this usb stick: https://www.amazon.nl/Kingston-DataTraveler-DTSE9H-16GB-USB-sticks/dp/B006YBARCA/ref=asc\_df\_B006YBARCA/?tag=nlshogostdde-21&linkCode=df0&hvadid=430623654457&hvpos=&hvnetw=g&hvrand=4285835131105129570&hvpone=&hvptwo=&hvqmt=&hvdev=c&hvdvcmdl=&hvlocint=&hvlocphy=9064325&hvtargid=pla-318320051986&th=1

Supports at an angle of 75, otherwise it might print supports under the fan wings. Advise: try to make the supports on the inside easily removable. I used a zig zag pattern that was perpendicular on the stick.

Also included a dual extrusion version. Black file is the main part and red is the accent. Could ofcourse choose different colours.

Inspired by the MSI GTX series graphics card. Had the 1070 ti model as reference while designing.

Used superglue to glue the stick in place. Could also use hot glue but don't use too much as there is not that much space for it.

Category: Gadgets