Sorting Boxes for LiPo Batteries in Ammo Cans
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For safe storage of LiPo Batteries I use used ammunition ammos which are available e.g. on ebay at low…
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 545
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
For safe storage of LiPo Batteries I use used ammunition ammos which are available e.g. on ebay at low cost. Important: The ammo cans are sealed waterproof. Cut out a small piece of the seal for possible exhaust in case of a thermal runaway!
To tidy up the batteries inside the ammo I created some sorting boxes. They fit into ammo cans with Size approx. 33 x 19 x 23 cm (50 cal)
The silde-in Covers contain some Icons for the charging status: Orientation of the Batteries inside the boxes shall show their status: Using Cover_H:
- Battery with Connectors located right = fully charged
- Battery with Connectors located left = discharged Using Cover_V:
- Battery with Connectors located up = fully charged
- Battery with Connectors located down = discharged Using Cover_Q (generic or mixed orientation):
- Battery with Connectors located right or up = fully charged
- Battery with Connectors located left or down = discharged
If your printer can print multi colours you can used a different colour for the Icons. But since the Icons are lofty this is not needed.
Category: R/C Vehicles