Easy Hummingbird Ant Moat
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are 3 sizes of hummingbird feeder ant moat. Needs some easy to find hardware & no supports needed!
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 106
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a set of Ant Moat models that take regular hardware. These are the hardware hooks I bought, overkill for sure but… I used 3D Fuels PCTG to stand up to weather and be easier to print that PETG, which it was! The print was simple and the hardware screws in by hand without any gaps that ants could fit in. Glue could be used if you were worried about gaps or strength. I can't remember infill but standard infill should work. I used my Elegoo Neptune 4 Pro with a MicroSwiss FlowFech Hotend.
5/26 Update, I recently printed the Large n Tall on my Snapmaker U1 w BIQU purple Glacier build plate in PCTG. No Supports needed!
I like to carefully fill mine w vinegar so no mosquito larvae which doesn't seem to upset the hummers. The new feeders seem like a fail because they have big holes which allows unwanted insects to go in and die. I've been using the large one for two or three summers with no strength or weathering problems.