Targa 1003 Fountain Pen Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pen holder made to scale for, especially, a Targa 1003 v1, might work with other Sheaffer Targa models.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 671
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Public Domain
Pen holder made to scale for, especially, a Targa 1003 v1, maybe some other Targa models will work as long as the diameter is still very similar to a Targa's.
There is a very small notch towards the back, this is for scaling, it represents 1cm. I didn't make the scale correct in blender so just scale it.
Should work with no supports, but you can use them to be safe.
Version pictured is outdated, changes have been made after observing initial results, mainly that it used to lack rolling supports, which are essential due to a high CofG.