Dyson Pro Vacuum Nozzle Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder in 45° angle, for Dyson Pro V7 , V8 , V10-V12 , V15
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 138
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
This is a Holder for Dyson Vacuum Pro useable for different versions. The Slots are lifted by 45° for easier tool placement and better printability in different to to the wall parallel orientated slots. Good for wide or deep nozzle, but long noozle may hanging to far in the room.
Printed in PLA works fine, but PETG may better for long-term. The tolerances of the modell works for me fine, but you may need to scale the modell by 0.5 or 1 percent for more clearance. Every percent add roughly 0.5mm in diameter. Even the original nozzle has not exactly the same size. The testprint is helping for finding the correct scale for your printer and material.
Printing: any Printer with at least 135mm in X or Y is big enough. Printer's nozzle diameter is best 0.4mm, layer high 0.15 or 0.20mm. No need for Supports or Brim.