1 / 6
Artillery SideWinder X2 - ADXL345 accelerometer mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Artillery SideWinder X2 - ADXL345 accelerometer mount
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 669
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 4)Remiksy (0)Kolekcje (15)Powiązane
ADXL345 accelerometer support
I've installed my Artillery SideWinder with Klipper firmware.
Determined to get the most out of it, I wanted to calculate the resonance compensation on its X axis.
To do this, you need to use an accelerometer (link to the one I used), which must be mounted as close as possible to the nozzle.
So I created this little bracket that attaches directly to the extruder.
I took care to :
- keep the overall dimensions as small as possible.
- not to compromise the rigidity of the support, so as not to induce vibrations due to a soft/wooby/loose support during probing process.
- keep it as close as possible to the nozzle, but far enough away to prevent melting
- designed to stay in place.
- easy to (un)mount.
BOM
- M3 * 16mm (x2)
- M2 * 5mm (x2)
Assembly
- Print the support
- Screw accelerometer to bracket with two M2 * 5mm screws
- Unscrew the lower 2 fan screws on the left side of the extruder.
- Fit the bracket and secure with two M3 * 16mm screws (the original screws must be replaced as they are a little too short).