Mazda 6 Park sensor rubber nubbin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement for the Mazda 6 park position sensor for the automatic shifter.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 163
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
The Mazda 6 (2014-19) with the automatic transmission has a common failure in the shifter park position sensor. The rubber nubbin on the end of the sensor wears down such that the car will not shut off because it thinks it is not in park. Mazda and 3rd party sellers only sell the complete switch assembly not just the tiny rubber nubbin in the end which is all that is needed. This is a replacement for the rubber nubbin.
Here is a good video in how to get to the part (and replace the switch if you want).
I printed it in TPU 95a at 100% and used a brim because it is so small. The brim may not be necessary though.
If you print in a rigid material you may want to scale up 1-2% to make it fit better. I made the hole a really tight fit with a little lip inside to catch on the factory stub. The TPU flexes enough to be pushed on and stay in place because of the little internal “clip”. With a rigid material you may have a hard time getting it on. You may want to remove the internal lip with a knife or file and just glue it in place.
Also, because of the way I modeled it in 360 it will import into the slicer with the opening down. Just flip it over, I can't be bothered to fix it in the model.