DANCO Twist Tight Kitchen Sink Basket Strainer knob
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement knob for the cast pot-metal piece on the DANCO Twist Tight that gloriously falls apart at inopportune times.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 103
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This kitchen sink basket has a fatal flaw... the knob is cast and will crumble and fall apart after a few years. Here's a compatible knob that I put together for 3D printing so you can save 10 bucks on a replacement strainer basket (and not contribute needlessly to a landfill for an otherwise perfectly good part).
Printed at 100% infll. It's small, and takes about 15 minutes total. If you find it difficult to slide the knob on, upsize the model 1%. Mine needed a little persuasion on the first try but after I scaled it, the second was just fine. The published model has already experienced said scaling.
(4-11-2025) Update: I have had to print this three times now and have gone from using PETG to PETG-CF. In addition, I have upsized the original to 104% to solve fitment issues.