1 / 6
Frame for Inky Frame 7.3
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a frame for the inky frame 7.3 with full access to all buttons, SD card and Pico USB
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 79
- Wydruki
- 0
- Wyświetlenia
- 600
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (7)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (11)Powiązane
Frame for Inky Frame 7.3"
This is a frame for Inky Frame 7.3" (Pico W Aboard).
It will allow you to put a 2000mAh battery with its charging circuit (which should last about a month if you update the screen every hour during the day).
Parts
This was designed to fit the following:
- LiPo Battery Pack – 2000mAh (you might need to reverse the wires)
- JST-PH 2-pin Jumper Cable - 100mm long
- LiPo Amigo Pro (LiPo/LiIon Battery Charger)
To close the frame you'll need:
- 7x Threaded insert M2 (4x for the back, 3x for the LiPo Amigo Pro)
- 4x M2x20 screws
- 3x M2x4 screws
Printing
Everything can be printed from PLA without support, just rotate the parts correctly in the slicer.
Building
- Put the buttons
- Put the metal leg screws in their dedicated holes
- Put all the inserts in place
- Insert the Inky frame in place
- Connect the jumper cable
- Put the inner plate
- Screw the LiPo Amigo Pro
- Connect all the cables
- Put the back and screw it
Contributing
I'll be happy to share the source if you want to make a few modifications, just contact me.