Molle support for walking stick and cane
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple Bracket/Support for a Walking/hiking stick or a cane
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 384
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Hello everyone.
After a surgical operation, I needed a cane to walk, and I had to do some physical rehabilitation like cycling.
But how to carry a cane that is 1 meter long when exercising?
My backpack had molle system on the back and the side, so I decided to design a simple bracket/support for my wooden Cane.
--------------------------------------------------------------------------------------------------------------------------------
The inside diameter is 28mm without the foam, im working on a parametric design so you can adjust the diameter as you wish.
Printing requirement:
- PETG/ABS/ASA
- 4walls
- 100% infill (dont worry, not that much more filament used)
Hardware needed:
- M3 nylock nut (optional)
- M3x10 screws (optional)
- Foam tape (optional) I used 2x10mm foam in my case.
It is not necessary to use screw/nut, in my case it is because my cane does not have the same width along its length. You can use it open, to clip your hiking stick inside
I used foam tape to be sure not to scratch the wood of my cane.
Use two of them, one at the top and one at the bottom, to have rigidity and that the cane does not move around.
Of course it can work for hiking sticks.
Thank you, and leave a like if your happy!