Crosswind Mini 1600 Servo Trays for 17G Sized Servos - Updated for better linkage clearance
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Larger aileron servo trays for the Crosswind Mini. Includes Fusion360 and Step files
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 87
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I had some ProModeler DS100DLHV micro servos laying around and wanted to use them in my Mini Crosswind. The servo trays are slightly bigger than the original so you will need to trim some foam to use them. They're 1mm wider and 5mm longer than the original holder. They're also taller than the original as well, but the covers compensate for this. I did make the servo covers with 2 extra screws. Not sure why they didn't come that way from the factory. So there are a total of 5 screws. I could have went with one screw in the middle on the back but would have made it to where they werent interchangeable from left to right. As the channel for the servo wire is pretty tight. So i just put one screw on each corner and called it a day.
The servo covers I would print on end. As they are in the STL file. Makes for a cleaner print at least from my tests.
For filament use whatever you prefer. I used ASA for some added heat resistance.
You will also need 5 - m2X6mm or m2X8mm self tapping screws. You could probably get away with some standard 2mm button heads but might strip them out if you over tighten them.