Siglent Oscilliscope Leg Props
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a device to extend the legs of a Siglent oscilloscope. I made it for a SDS1202X-E but I assume it would fit…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 94
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a device to extend the legs of a Siglent oscilloscope. I made it for a SDS1202X-E but I assume it would fit their other model. Post a comment if you find it fitting other pieces of equipment (although I still can't see people's comments). I found, that using the scope on my bench, it was difficult to read the top of the screen and I needed to tilt it back more. I started propping up the front legs so I built this prop. It has 3 positions that lift the front up about 2", 2.1, and 2.3 increasing the tilt.
Printed mine with 20% fill using PLA. No support needed.
Category: Electronics