VENOM GABOON GRIP
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
REPLACEMENT VENOM PRO GRIP IN CONJUNCTION WITH DUAL STAGE TRIGGER SET UP ***NUBS FILE MODDIFIED 3-11-25***
- Ocena
- 5 / 5
- Polubienia
- 28
- Pobrania
- 68
- Wydruki
- 3
- Wyświetlenia
- 781
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Introducing the Gaboon Grip for the Venom Pro. This grip deletes the rear rev trigger. The blaster must be equipped with a dual stage trigger set up in order to operate properly. Grip is contoured to fit bigger hands and features a flared mag well. The grip also has a sling loop in the back so you can rush without worry. This grip uses the original hardware. Be careful with the mag release spring. It likes to fly to the floor. Clock the front offset screw nubs toward the front of the Blaster. Glue the screw nubs into place. Clean out the mag release ledges in the well for smooth operation. Adjust the mag release catch as needed. If the magazine has to much friction heatgun the top finger groove on the front of the grip and slide the magazine in. This should correct the tight tolerance. Glue the GMR C into the mag release screw hole and you are done. Let the glue on the cap fully cure before operation. Insert mag to relieve pressure off of cap. Please message me with any questions and concerns. AND SHOW ME THOSE SWEET PICS!!!
***Mag Release update 10-9-24***
***Magwell Calibration file added 3-11-25*** (Section of the grip to tune magwell size to maganzine using xy compensation in slicer software)
***Nubs file update 3-12-25*** (Front nubs offset and wider for better attachment to the blaster)