Gridfinity carrier with 2x4 side (added 3x4 and 4x4)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Carrier with pause magnet insertion for gridfinity containers with 2x4, 3x4 and 4x4 grids on each side.
- Ocena
- 5 / 5
- Polubienia
- 33
- Pobrania
- 91
- Wydruki
- 2
- Wyświetlenia
- 575
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
The center handle is best printed with top of handle down. This allows the part your hand will grab to be smooth. This requires supports for the curve and inside of the handle.
The carrier side is mirrored so you need to print two. I would test fit with the first. This is using my grid CAD that I drew to do pause insertion of magnets. When I slice using a 0.4 nozzle and 0.2 height, I add a pause before layer 15 to insert magnets. Look at your slicer and typically you pause when the first printing over the hole is shown. You will use 6x2 magnets.
I have had no problem with slightly loose magnets as the print head attracts them but also pushes them back with flowing plastic. However, best results are made when you tune the hole size in slicer. I found that -0.05mm gives me just snug insertion.
Assembly uses M3 square nuts and 6mm M3 flat head bolts. The pockets align them vertically and you loosely thread in all bolts. Then assure the carrier is pressed up into the pocket before tightening.
I designed this for the 7 height containers I typically use and likely it could handle 8 with no issues.
Per request I added 3x4 and 4x4 sides. I would not use 4x4 for heavy holders like bolts, etc. I have only built the 2x4, so please let me know if there are any problems with the others.