Seed / Bulb Dibber

Updated 4/1/25: At user request added ¼" hole spacing and a 10mm version for smaller seeds. While i was editing the model i also made a few other variations. I found the original a little small for some of the garlic i was planting so there is also a larger 30mm model with enhanced length for larger bulbs.  I also added the step file for all included models for remixes. The original 20mm / ¾" model is unchanged so there is no new file for that size. i have not printed these new sizes yet to verify they fit, but i kept the same design tolerances that worked with the original dibber so everything should fit well without stretching or scaling on the slicer. 

Please print the correct sized knob for each shaft, they are not interchangeable. 

Printed in PETG with 35% infill and 0.24 layer lines (0.20 layer lines in included g code). model requires 1 M3 screw, or something like a piece of filament to shove in the hole to keep the slider in place during use. print as shown in the included G code, there is 0.5mm of clearance built into the slider already so stretching of either model should not be required. Soil hole diameter is 0.75", STEP file included for easier modification. 

Please do not take internally.