1 / 2
Detailed Calibration Tower
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made yet another temperature tower because I couldn't gauge how smaller details were affected with other temperature…
- Ocena
- 4,833 / 5
- Polubienia
- 113
- Pobrania
- 1246
- Wydruki
- 10
- Wyświetlenia
- 8534
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 10) (Komentarze: 15)Remiksy (0)Kolekcje (236)Powiązane
I made yet another temperature tower because I couldn't gauge how smaller details were affected with other temperature towers on Thingiverse. Printed in PLA, it only uses about 4 grams of filament.
Each section is 10mm tall
4/4/21 Update: I added a new version that has a floor. This should be less likely than the original to have bed adhesion issues.
This tower has the following features:
- Small text to see fine details
- Thin walls
- Thin cylinder and a thin angled piece
- A thin cone. In the design, the cone goes all the way up the top of the level. Your slicer will make it shorter depending on nozzle width
- Bridges
- Overhang at 45 degrees, 55 degrees, and 65 degrees
- The side with circles inside of rectangles shows extruded and embossed geometry. The rectangles are embossed or extruded, the circle parts are level with the main wall. The left column is extruded and the right column is embossed