1 / 2
Prusa MMU Spool Holder Bearing Adapters — zdjęcie 1
1 / 2

Prusa MMU Spool Holder Bearing Adapters

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An upgrade for the spool holders included with the MMU3 kit to use 608 (8x22x7) bearings.

Ocena
3 / 5
Polubienia
2
Pobrania
21
Wydruki
1
Wyświetlenia
111
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

The spool holders that came with the MMU were noisy and did not seem to roll particularly well. I threw together this simple model to replace the included injection-molded rollers with bearings. 

This is a simple and quick print in 3 parts:

  • The bearing axle with a spacer
  • A bearing spacer (axle collar)
  • The bearing outer sleeve

Hopefully they'll print with less stringing than I show in my photo. ;)

The parts fit my bearings very well, but, as walways, you may want to test and adjust fit to suit your filament/settings.

 

Additional Parts Required

You will need 20 608 bearings.

 

Assembly

If you print using the provided 3mf file, the axle and one spacer are already oriented to be printed as one piece. Otherwise, you'll need to print one axle, two axle collars, and one bearing sleeve for each wheel replacement. Twenty (20) of these sets is required for a full replacement.

First, slide a bearing into the large ring (bearing collar) and press into place. Position is not critical but I more-or-less centered the item by using a washer under the baring and pressing on the outer collar.

Next, slide the axle through the bearing and set the other axle collar on the other side, sandwiching the bearing.

Finally, drop the new assembly into the socket in one half of the molded frames and re-assemble.

 

 

 

Tagi