1 / 4
Plinko Dice Tower With Magnetic Latch and Detachable tray — zdjęcie 1
1 / 4

Plinko Dice Tower With Magnetic Latch and Detachable tray

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

After using my old dice tower for over 2 years, I had some ideas for improvement.

Ocena
5 / 5
Polubienia
31
Pobrania
95
Wydruki
0
Wyświetlenia
1236
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Board Games
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

After using my old dice tower for over 2 years, I had some ideas for improvement.

  • This new one features a print-in-place hinge design
  • Low walls on the tray ensure that your dice are easily readable after a roll
  • During play, use the detachable tray to keep your other dice nearby
  • When it's time to go home, just fold the tower down.
  • When folded, the two trays allow you to store dice and minis separately. (delicate 3d printed minis won't get smashed)
  • Magnets hold everything closed and together
  • I tried to make it look a little castle-like with a brick wall generated in Tinkercad and a castle door made by drxenocide

This uses 8 8x3mm magnets. Here are the ones I used: https://www.aliexpress.com/item/1000008645137.html

After printing, insert the magnets into 4 holes in the detachable tray, 2 holes in the attached tray, and 2 slots in the tower. Be sure to get the polarities lined up before you push the magnets into place so everything attaches correctly. Use a bit of Gorilla Glue or something similar to secure them.

7/11/19 update - I uploaded a version without the castle texture

Print instructions

Supports: No

Resolution: 0.2mm

Notes:

  • 0.4 nozzle width AND extrusion width. A wider extrusion width (PrusaSlicer defaults to .45) may cause the features on one side to show through on the other side more
  • Use 3 shells for the main tower to make sure the pegs don't break when dice hit them. The trays can use 2 shells and lower infill if you want to save filament and your slicer allows you to change their settings separately

Tagi