Drawer Base for Top Heavy Items
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I have a deep drawer in my bathroom vanity that has power. This allows top heavy items to be plugged in and not topple.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 120
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
When moving into a new house there was a deep drawer in the bathroom vanity that had a built in power strip. The perfect place to charge razors, electric toothbrush, etc and keep clutter off of the counter. The one problem was that these are top heavy items and tend to fall over if you open or shut the drawer too quickly. I designed and 3D printed these bases that interlock together and are modular. They provide a steady based for the items.
A heat set insert goes in the middle and a strong neo magnet is screwed in from above. I simply JB welded a steel washer to the bottom of the chargers and they were complete. The washers are low enough profile that the chargers stand on their own should you want to not use this in the future. These blocks also have zip tie pass through to assist in cable management.