1 / 4
Moza SRP Pedals to Playseat Challenge X Attachment Supports
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These parts allow me to attached my Moza SRP Pedals securely to my Playseat Challenge X.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 145
- Wydruki
- 1
- Wyświetlenia
- 1112
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 1) (Komentarze: 6)Remiksy (0)Kolekcje (11)Powiązane
Inspiration came from https://www.printables.com/model/525141-moza-srp-to-playseat-challenge-adapter. But its a fundametally more comprehensive build and mine is for the Challenge X where as the linked project is not.
Some notes:
- I have two pedals only. And they are 1 position inwards from the furtherest out positions. Put another way, if there are 9 positions that the pedals can be attached to the heel support, my pedals are in positions 2 and 8. If you want to add a 3rd pedal and have it supported at the rear, let me know and I can modify (or supply the 3D models exported from Fusion).
- The front support has holes for the Playseats tubes to slid into. You will need to slightly dissamble the Playseat equipment to slide this into position. It should be fairly obvious how.
- No tapping required. Just screw in your hardware. But go gently, its a tight fit. Probably using some grease when screwing in the hardware would be wise.
- Hardware required
- M6x30mm (2 off) for the front support
- M5x30mm (6 off) for the rear support
- I printed in PLA with 3 walls and 15% infill. If rotated correctly on the bed, no supports are needed.