1 / 3
Elegoo Heater Mod
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This mod is designed to do FOUR things.
- Reduce the vibration of the heater in the printer.
- Strengthen the mounting of the heater
- Force the Heater to pull cold air from below the VAT as not to disturb the resin.
- Pipe the Heat above the build plate so as to not add heat directly to one side of the build plate.
Bonus - It Looks fun and is easy to install.
Can CAN get away just using the bolts that come with the heater, as the holes are just small enough that an M3 screw will thread and hold just don't go too tight.
Recommend: M3 bolts and nuts 8mm -10mm in length, M3 washers, 4 Rubber washers are also recommended