Custom Fingertip Mouse V4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A sub 20g fingertip mouse for the vgn f1 internals.
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 272
- Wydruki
- 0
- Wyświetlenia
- 2513
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
THIS IS NOT FINISHED
Measurements may not yet be perfect, it is a work in progress. I ordered the print in 9600 resin from jlcpcb, and the part has to flex a LOT currently to get the pcb into position. I doubt it would work with sls or mjf so if you print with it (or any other less flexible material) it will likely snap. I plan to change this in the future as I would prefer to print it in nylon sls. The resin print came warped so I had to fix it in hot water. In short, dont expect a working mouse from this print, it needs work.
To build it, you will need to solder a new 5mm encoder and a 3.5mm tact switch for middle mouse button. I ordered the kailh red encoder and some huano mute 6*6*3.5 switches. The smaller printed scroll wheel is required for it to fit. I also used a 150mah battery to get the weight under 20g. The pcb screws in with the stock screws so no more needed. For skates, I use 4 x-raypad Jade dots.