1 / 3
Single Extruder - Dual Color - Octopus (fusion360)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An Octopus model modified with the dual color technique. The model prints in two part that slide into each other.
- Ocena
- 4,5 / 5
- Polubienia
- 187
- Pobrania
- 547
- Wydruki
- 2
- Wyświetlenia
- 2138
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Sculptures
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (8)Wydruki i komentarze (Wydruki: 2) (Komentarze: 11)Remiksy (0)Kolekcje (223)Powiązane
The fusion360 file is given would you like to see how I did it, to modify it , …, or if you simply want to adjust the tolerances to your needs for example.
The model tries to depict a Blue-ringed octopus, the most commonly known toxic octopus. In reality the animal has blue rings but in this model I had to open them up a bit to allow connections between the inner and outer parts.
Printing info:
- Scaling down can be tricky since the tolerances will scale accordingly aswell, I recommend tweaking the tolerances in fusion first, then to scale it as you wish.
- Split the model to its parts before printing them separately then, when done, they should simply slide into each other
- The rings make the model more difficult to print, you will have to take some time (~10min) to clean up the underside by removing all supports. I recommend using normal concetric supports as they are easier to remove in this case.
---
Erratum (07/04/25): Correction of the .f3d file (tolerance control issue resolved)