1 / 6
Bike Helmet Visor Devil Horns 3 Ways
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Another exercise in fastener options. Made to fit a bike helmet with M5 sized visor mount holes.
- Ocena
- 5 / 5
- Polubienia
- 28
- Pobrania
- 96
- Wydruki
- 2
- Wyświetlenia
- 710
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Costume Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
SzczegółyPliki (7)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (0)Kolekcje (43)Powiązane
3 options:
- Two Halves: Weakest option, but no hardware required. Split to allow printing without supports and to give the threads an iota of hope as far as layer integrity. Print the horns in two halves and glue the pieces together. The thread alignment is critical and M5 doesn't leave much to work with. I would consider this good for about one installation and removal.
- Glue In Place Bolt: My favorite! Print the GIP option and glue and M5x20 bolt into place. There is a plug to glue in after bolt placement to provide additional glue surface and longevity. For the horn point, I used tree supports at 45° threshold. (I added a support blocker for the bolt hole.)
- Thru Bolt: With this option, bolt the print to the helmet and then place the fitted plug (if desired). If you glue the plug in place then you can't remove the horn or adjust the bolt fitting. I would use a little thin double-sided tape. I did add a notch for removal of the plug. For the horn point, I'd use tree supports at 45° threshold.
I printed the washers in TPU just to provide a little adjustment to the position and bolt fitting.
Thanks for looking!