JK BMS to Pace LiFePo4 box kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Kit to replace Pace BMS with a JK BMS in a server rack battery box.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 79
- Wydruki
- 0
- Wyświetlenia
- 1181
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Kit to install a JK BMS RESS (JK-PB2A16S20P) into a server rack battery / lifepo4 case originally delivered with a Pace 200A BMS (other models like 150A might also be compatible).
Print mounting point adapter with supports.
I used organic supports with Paint-on supports/Automatic painting (PrusaSlicer 2.8.1).
Spacing between the screws is 100mm. In my box the diameter of the stands was 5.4mm and I decided to add hollow legs to bring more support instead of relying only to screws.
Power button spacer is used to install a 12mm power button to the original 16mm hole - this is a bit for decoration only when using a display (which uses the same port in the BMS).
BMS slides into the adapter - hole for the BMS is 100x18x10mm and should hold BMS snugly in place with access to all essential places. Use original screws to install adapter in place.
Display sleeve is made to fit JK BMS 3.2 LCD Display snapin bracket by @Ron_168842 - just install the original backwards and bring display cable through the main hole. Install displayclip to the sleeve, hold it in place from inside the box and push display-side to the clip which then keeps the whole assembly in place. Hole where the original Pace display is installed is about 79mm x 51.5mm.
You need two power button spacers (for both sides of the box facing each other, new power button keeps the construction in place), two mounting point adapters (one for each end of the BMS). I used PETG.