Railcore LGX toolhead mount for filament sensor using Euclid probe and V1.1 1lc toolboard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is my toolhead mount for the railcore using an LGX extruder with mosquito hotend, Euclid probe with a 1lc strapped.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 160
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
please see the original model for instructions. This model uses many heatset inserts. Feel free to modify the design as needed (the .step file is attached).
Keep in mind this is for the V1.1 revision of the 1LC board, if you have a different version you WILL need to adjust the hole spacing.
On the V1.1 board, you can solder in a JST 2.54mm 5 pin plug (snip off the 2nd and 4th pins) and it will fit right in the spot meant for the limit switch. This will retain the normal railcore limit switch mounting location.