Poop Chute Optimized

Loved the idea of the original, especially the simpler “just glue a magnet inside” approach, but the model had a few areas with inconsistent sweep widths leading to some odd print layers.

I remodeled this from the ground up. I still consider it a remix but, aside from the “machine” in the fusion file, all the parts have been re-created. Some key differences:

• There are no specific internal magnet spaces – just glue in you whatever size magnets you have
• The walls are all a very consistent width – with Archane you should see 4 walls on all the parts of the model nicely
• The “against the machine” wall was removed
• The tray uses a gridfinity-like footing

I've only printed this once with 2 walls, 0.28mm layer height, and 10% gyroid infill in PETG. It came out very functional, but I had a lot of stringing on the interior space. You might wish to print this sequentially (which can still be done on a single plate; put the tray in the front) to get better print quality – or just have better luck with your settings/material ;)

The print nets a slightly larger bucket, yet prints a few minutes faster and uses a smidge less filament.