1 / 4
Flywoo Goku GM10 Nano V3 GPS mount for Crux35 — zdjęcie 1
1 / 4

Flywoo Goku GM10 Nano V3 GPS mount for Crux35

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

GPS holder for Flywoo nano GPS mounted on the top of the frame

Ocena
0 / 5
Polubienia
2
Pobrania
161
Wydruki
0
Wyświetlenia
520
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Share Alike

Angle 40°. 

Version with mount above the camera stands, and version to use 20 mm holes. 

I printed with TPU-like filament with supports.

P.S.
Have not tried to connect GPS yet, will need soft serial for extra UART.

P.P.S.
Official guide from the Happymodel:

1. Solder analog VTX data wire to “LED_Strip” pad then Enable SOFTSERIAL from Betaflight configurator

2. Go to CLI command type the following command to remapping “LED_Strip” pad to “SOFTSERIAL1”

resource LED_STRIP 1 none
resource SERIAL_TX 11 A00
save

3. Go to Port tab and set Softserial for TBS Smartaudio (VTX).

P.P.P.S.
If your VTX is not analog, but digital it use both TX and RX and you do not have extra pins on the board, unfortunatelly.