1 / 1
Glock Trigger Guard
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
It is a trigger guard for Glock pistols. I carry mine in pocket and designed this to block the trigger from going off accidentally by snagging on something in my pocket while carrying. I have tested this on Glock 19, 44, 43x, Combat Armory, PSA and SCT frames. Since most glocks use same frames (G22, G48), this should work for most Glocks.
I have other guns and some have a safety and some not so decided to standardize on having a trigger guard as a manual safety for all of them to have same safety drill. Simple design created in Tinkercad.
Print Details
- Filament - PLA, PETG or PLA+
- Infill - Anything above 20% would work
- Resolution - 0.2 mm (anything up to 0.4mm is fine).
- Supports - None.
- Others - Ironing enabled. This was done to get a smoother top layer finish. Increases the time but gives a much better result at resolutions of .2 or higher.