Sovol SV08 Bed Riser Strips (Taco bed fix)

I created this to help with the Tacoing of the SV08 bed. Some of the Sovol SV08 beds center along the Y axis is lower than the left and right side on the Y axis. This causes the Taco effect. I made 320mm x 25mm x 1mm strips that when placed under the bed can help this problem. I also added the STEP file incase you need to make it thicker than 1mm. Let me know in the comments if you are not able to do this and need it thicker. I have added before and after pics of my bed after doing this mod. 

Make sure you print in PETG,ASA, or ABS!! Print with 0.20mm thickness. with 2 walls and 5 top and bottom layers so there is no infill (see pic for settings) 

I have added a picture to show the screws that you remove they are circled in red. The blue circles are not visible without cutting the magnet sheet, which I have done. That is why you see them in the pic.

Here are the instructions. Please let me know if you have any questions.

1. Print 3 strips in PETG, ASA, or ABS.
2. Pop off your bed sheet
3. Unscrew the bed with the 6 visible 3mm Hex head screws (circled in red). ( you don't need to cut the magnet sheet)
4. Place 3 of the strips along the Y axis next to each other so they are in the center under the bed
5. Screw the bed back down

------Update 10/1/24-----

EDIT: from the comments (@ss1gohan13_1260760) it was brought up that I didn't have a full mesh showing the whole bed. This was not on purpose. I have since removed the smaller bed mesh and put the whole bed showing the flatness compared to the original. There is still some slight curling at the leading edge of the bed. While this mod helps the overall flatness of the bed it is still no replacement for an actual flat bed.