Skateboard MK2 (old version)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This skateboard is almost completely 3D printed, both the trucks and the board.
- Ocena
- 4,667 / 5
- Polubienia
- 839
- Pobrania
- 1878
- Wydruki
- 3
- Wyświetlenia
- 19 351
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an old version. You can find the updated version here.
Introduction
I'm Seb, I'm a student and I've been working on the idea of 3D printing a skateboard for more than 2 years. The goal was to print both the trucks and the board itself. Many people said that it's not possible, it breaks immediately, FFF 3D printing can't do that. This article is the proof that it works. Thanks to all those who didn't believe it and even more to those who were always by my side.
The Skateboard is 55 cm long and is therefore a mini cruiser (also known as a pennyboard).
The instructions are available as a PDF, be sure to take a look at them. There you will also find more general information. Read them carefully. If you have any problems, write a comment or a direct message here. I will do everything to help you. This also applies if you have ideas and suggestions.
Thank you very much, I can't wait to see what great skateboards you will build.
megalog_