Saturn 4 Build Plate Handle 1.0
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Handle for Elegoo Saturn 4 / 4 Ultra build plate.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 795
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
Version 1.0, 3 files: the whole uncut version, and the left and right halves with 10mm deep keyed joints (0.15mm tolerance). Some questionable 3dsmax Edit Poly + Turbosmooth methods I just started to relearn, so not well optimized.
The uncut version needs to be cut and keyed / fasteners added based on the way it slides onto each side.
The handle is a bit egg shaped to give a more positive orientation grip and placed low out of the way of the latch. There are catches that go under the spring / leveling box. These may get immersed in resin with a full vat which could weaken the handle to failure, so keep that in mind.
The halves will fit on the S4 / S4U build plate though, so it can be printed in resin. Strongly recommend ABS if SLA resin printing for the necessary strength and flexibility. This model is likely poorly optimized for FDM printing even though handles and similar hard parts should usually be FDM.
Requires no screws and will work without glue but feels a lot more solid glued. Recommend finishing with varnish / shellac / paint / clear coat for regular contact.