1 / 3
Dell RTX 3070 2 x 120mm Fan Shroud — zdjęcie 1
1 / 3

Dell RTX 3070 2 x 120mm Fan Shroud

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Shroud to allow for 2 x 120mm fans for the Dell RTX 3070 - Quieter and cooler than stock.

Ocena
5 / 5
Polubienia
7
Pobrania
81
Wydruki
0
Wyświetlenia
811
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
GNU General Public License v3.0

This will fit the width of the print bed on a MK3S+ almost exactly.
Material: PETG (PLA might be ok but it may warp with heat over time being close to the GPU)
Supports: None
Infill: 20-30%

I found a cheap Dell RTX 3070 during the pandemic and was happy with its performance, its just a rebadged MSI after all, but the twin fan OEM setup is very loud when pushing it in most games.

This shroud allows for two 120mm fans with a small cutout for cabling straight into the card aswell as the fan overhang being redirected into the finstack.

I recommend an adapter for each fan as running both 120mm off a single GPU fan header can cause some erratic fan speed reporting and ramping behavior as it seems to expect a fan on each header. The card uses the ‘mini 4 pin PWM’ header, or sometimes simply called GPU PWM header or similar and can be got for a couple of dollars off whichever marketplace you'd prefer.

The model had several iterations mainly figuring out the nicest setup for the tabs to sit on from the OEM heatsink as they stick up and getting the screw holes to line up nicely, I haven't actually had a chance to print this final model as I was impatient and simply drilled the screw holes on the version prior as I'd gotten top and bottom mixed up at one end so the screw holes were swapped.

The card is now considerably quieter and marginally better cooling performance, it does make it a chunky GPU though as can be seen in pictures.

Tagi