BottleCutterV4+ROD
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bottle PET CUTTER
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 228
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Description
A bottle cutter that uses 608ZZ skateboard bearings (8x22x7mm), and US pennies or 5/16 washers to adjust the cut width.
Parts
2, 608 bearings (8x22x7mm) (Grind at least one side flat to use as a shearing surface. I used an angle grinder and then a Dremel with a sanding head to smooth it out. If the surface is rough it is Much harder to cut the plastic.)
2, 5/16 or 8mm bolts and nuts ( Fully threaded bolts and 8mm bolts may need shims for the bearings to overlap properly. There is a remix that moves the bolt holes closer together if the holes don't work with your bolts.)
Several US pennies or 5/16 washers. Any metal disk with a diameter less than 19.2mm will work.