1 / 4
Magnetic Pogo Pin Connector Housings — zdjęcie 1
1 / 4

Magnetic Pogo Pin Connector Housings

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

In-line Housings for 6 pin and 2 pin magnetic pogo pin connectors.

Ocena
0 / 5
Polubienia
16
Pobrania
81
Wydruki
0
Wyświetlenia
789
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

These are resin-printable housings for magnetic pogo pin connectors. Included are high current two pin barrel connectors and two designs for 6 pin connectors.  I may add a low current 2 pin connector in the future. I doubt that any of these exept possibly the barrel connector can be successfully printed by fdm.
It would take too long to explain why, but I soldered molex pin headers to the magnetic connectors so I could use female molex headers to attach to the mag connectors.
The housings have room for this but you can connect however you like.

The original 6-pin housing was also an experiment to see if I could have a protective housing with an outer flexible shell to hold it together and provide a good grip, as well as provide a way to add strain relief in the future. I was frankly surprised how well this worked and I recommend it.  However, flexible resin is not easy to print and is expensive.(although fexible-X is fairly easy to print but very expensive).  The high current 2 conductor is designed for flexible resin only.

In case someone actually finds this useful(!) but can't go the flexible route, I added a design that is assembled with screws.  It uses 2 3m x 8mm screws and nuts.

Tagi