Dillon XL 650/750 Dual Toolhead holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
storage rack for dillon xl650/750 reloading toolheads.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 94
- Wydruki
- 0
- Wyświetlenia
- 454
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Dillon XL 650/750 Dual Toolhead holder.
Original model by RC builder. I did not need all the accessory pockets since I still store those in the Dillon cases. I removed them and made it into a double stack holder to fit my cabinet. I printed three units and used double sided tape the secure them together and to the back of the cabinet so they wont move around when pulling the tool heads out. I also thickened the legs to 10mm’s.
Print settings:
Printer: MK3s+ with Bondtech extruder and Revo hotend.
I used Sunlu PLA+ on smooth sheet at 70c temp
Revo 0.6mm nozzle with 4 layers perimeter, top & bottom. Infill was 20% triangle and did use variable layer height. Print time was about 16hrs with a total weight of 515grams.
If I had to print them again, I would have just done a 3-layer perimeter and dropped the infill to 10-15%. This would have let me get at least 2 out of one roll. And reduce time a bit.