Earbud Winder - Print in Place
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an earbud winder for your small wired earbuds and keep them from tangling. Don't forget to lubricate
- Ocena
- 4,364 / 5
- Polubienia
- 92
- Pobrania
- 534
- Wydruki
- 14
- Wyświetlenia
- 1952
- Oceny
- 11
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a model I designed years ago to keep my cheap earbuds from tangling up in my backpack. This has been rattling around in my front pocket for years and still going strong. Just place the buds and twist away!
It prints in place and you should be able to pick it up from the build plate and brake it loose. It is possible to pry the outer ring off, so be careful. Depending on the filament it might not be smooth to turn, but with a little bit of silicone or teflon spray it will turn very well. Just on both sides of the outer ring, rotate a bit and wipe off the excess:
These fit all the standard small earbuds that I bought over the years, but bigger models might be challenging without scaling up the model.
Happy printing! And don't forget to like, download and follow if you like my models :)
Cheers ,
Rossero