1 / 6
Wall mount adapter for the Bluebrixx Star Trek USS Voyager display set — zdjęcie 1
1 / 6

Wall mount adapter for the Bluebrixx Star Trek USS Voyager display set

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A wall mount to vertically mount the large brick build USS Voayager (104966) by BlueBrixx vertically.

Ocena
0 / 5
Polubienia
7
Pobrania
25
Wydruki
0
Wyświetlenia
611
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Wall-mounted
Licencja
Creative Commons — Attribution — Noncommercial

The mount is separated in three pieces to the top arms more strength through layer orientation.

You'll need to make a few minor changes to the model.
Under the removable landing gear, switch the 2x8 brick and the two 4x1 bricks on both side with technic bricks two 1x4 and two 1x8.
The inverted slopes on both sides are connect by a wild plate/jumper plate contruct,
you just need the existing inverted slopes with the existing 2x2 plates and add four 2x1 plates with one stud in the middle  - two for each side.

You'll need two 6L axles, two 5L axles, two 4L axles, four 2x2 bricks with axle hole (can be round from the stand) and some technic bushings.

The 4L and 5L are connection the 2x2 bricks to the print and are secured by the bushings on the underside.

The moddel now has 16 studs to connect to and two 6L axles are pushed from the side through the print and the technic bricks we placed in the secondary hull.

 

I hope the pictures explain it better :-D


So parts you'll need (partially found in the original stand):

  • technic bricks
    • two 1x4
    • two 1x8
  • Axles
    • two 6L
    • two 5L
    • two 4L
  • technic bushing
    • at least 4 better 12
  • 2x2 bricks with axle hole
    • four
  • modified plate 2x1 with one stud in the middle
    • four in LBG
       


 

Tagi