1 / 1
QIDI Q1 Pro Führung PTFE-Tube — zdjęcie 1

QIDI Q1 Pro Führung PTFE-Tube

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Verhindert das Verhaken des PTFE-Tubes an der Schleppkette.

Ocena
5 / 5
Polubienia
48
Pobrania
436
Wydruki
4
Wyświetlenia
1872
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Bei meinem Q1 Pro ist der PTFE-Tube hinten an der Schleppkette hängen geblieben wenn der Extruder von rechts hinten nach vorne gefahren ist und hat dabei das erste Glied der Schleppkette aufgebogen.

Um das zu verhindern, habe ich eine kleine Führung konstruiert, die den PTFE-Tube immer über der Schleppkette hält.

Die Führung wird hinter die Montageplatte der Schleppkette geschraubt, es werden zwei etwas längere M3-Schrauben benötigt.

-----------------------------

On my Q1 Pro, the PTFE tube got stuck at the back of the drag chain when the extruder moved from the back right to the front and bent the first link of the drag chain.

To prevent this, I designed a small guide that always holds the PTFE tube above the drag chain.

The guide is screwed behind the mounting plate of the drag chain; two slightly longer M3 screws are required.

 

Print Settings

Printer: QIDI Q1 Pro

Rafts: No, maybe some Mouseears

Supports: No

Nozzle: 0,4

Resolution: 0.2

Walls: 3

Infill: No

Filament: JAYO PETG black