The jumper wire mag
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A parametric magazine (of sorts) for holding jumper wires
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 259
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This model accepts gluing 4 6mm x 2mm magnets (sizes can be customized in the fusion 360 project). They are not required, but improve the ability of the arms to hold the jumpers a bit tighter, and allow quickly snapping into other mags. In mine, one arm pair has the polarities swapped, so they can snap together only one way.
Each mag holds 20 jumpers. This can also be customized, but I'm not sure I'd recommend. Less is wasted space, and more make it too floppy.
The WireLength is the most important customizable parameter. It specifies the length of the wire (only the visible wire, before the start of the connector). Each of my jumpers connector type combinations (MM/MF/FF) have different lengths, hence the three different versions I included. Yours may likely vary
The model exports laid down, but the best print orientation is upright