Crush - Quick Swap Picatinny Sling Point
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Quick-Swappable sling point for the Rush/Crush/Lush/Mush etc
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 511
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
If you've made a Crush with a quick swap stock, you may have found yourself wondering:
“Self, what am I quickly swapping in when I quickly swap out my quick swap stock?”
Well, here is a possible answer - a quick swap sling point!
This sling point uses the same design and hardware as Chance's quick swap stock, so it can be swapped quickly.
Hardware:
2 M3x30mm socket head screws
2 Chunks of spring. I used the springs from two BIC 0.7mmHB#2 mechanical pencils. If you have kids there are at least two of these in your couch already, but anything small and around 12-15mm in length should work.
You will also need to print out StockReleaseSmooth.stl and StockRelaseButton.stl from the Crush file set.
Assembly is the same as the stock attachment point detailed on page 22 of the Crush build guide.
While this was intended to be used on the back picatinny of the Rush and it's kin, it can potentially be used on many other picatinny rails. Many 3d printed rails (and retail blaster rails *cough dart zone*) are non-standard and this may or may not work on them. Try it out! Your imagination is one limit!