Lack magnetic enclosure door stopper and handles
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic door stopper and handles for Ikea Lack/table based enclosure.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 212
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I was looking into making a certain table based enclosure for a printer and found a few similar designs, some of which used a rectangular magnet for the door stopper, which was difficult to find (for me anyway), so I decided to make my own version which uses Ø6x3mm magnets which are cheap and easy to find.
The stopper uses 4 x 6x3mm magnets, with 2 x M4 countersunk screws to hold it in place. The handles use 2 x 6x3mm magnets each and work on either side. If you want, you can use only 1 magnet pair per side instead of 2.
No supports required and printed in PETG with 20% infill and a 0.4 nozzle for the correct hole sizing, which doesn't require any glue to hold the magnets in place. The slot on the handles is sized for 3mm thick panels and also has a slight taper so it fits nice and tight on the panel.