1 / 2
Ender 3 V3 SE/KE Side Spool Holder. Less gantry wobble. Extra Support Clip
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spool Holder Extra Support
- Ocena
- 5 / 5
- Polubienia
- 176
- Pobrania
- 1497
- Wydruki
- 13
- Wyświetlenia
- 4487
- Oceny
- 12
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 13) (Komentarze: 13)Remiksy (3)Kolekcje (238)Powiązane
I made this little clip for extra support for the original Side Spool Holder since without it it tends to bend after a couple weeks.
Works with: https://www.printables.com/model/776235-ender-3-v3-seke-side-spool-holder-less-gantry-wobb
Infill: 15%
Supports: No
To Install, Remove the roller and take the Spool Holder off your printer, keep the metal thing still attached. Using a screw driver and “hammer”, slowly push the clip in. Make sure it is going down at the same rate on both sides until it sits a top of the Spool Holder.
